[. . . ] Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. the appliance is designed exclusively for private use and for the envisaged purpose. Do not use it outdoors (except if it is designed to be used outdoors). [. . . ] This is normal and does not affect the correct functioning of the device!Do not place the machine directly next to a gas or electric cooker or any other source of heat. Before opening the water tank switch the machine off and allow it to cool down for at least 30 seconds!Putting the device into operation remove all the packaging and transport protections from the device. Wipe all the parts with a moist cloth to remove all the dust that may have deposited on and in the device during transport. Carry out 2 or 3 cycles with cold water only to clean the device before brewing the first cup of coffee. Make sure that the appliance is switched off (The light in the I/O switch is off). Fold the paper filter (size 1x4) along the lower folding line and then place it in the filter funnel. Note: Due to the fast brewing process and the high temperature, less coffee powder than normal is required (max. By removing the pot, before the water runs through the filter completely, it avoids that the coffee drips on the base. If there is still water in the tank or filter, make sure that the pot is placed back under the filter to avoid overflowing. When the coffee stops flowing into the filter, you can remove the pot. When pouring the coffee out of the pot, turn the lid through a half turn if you wish to pour slowly and a complete turn if you wish to pour quickly. To keep the coffee warm, put the lid back on (The dot on the lid is pointing towards the handle). Always pull he plug before cleaning and wait for the appliance to cool down. Clean the outside of the appliance, if necessary, with a slightly moist cloth without any detergent. [. . . ] Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. ) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs. [. . . ]